For 1990-2009 cars only
Removal Procedure
- Use a flat-bladed tool in order to pry the end of the rear window reveal molding out approximately 75 mm (3 in) from the body.
- Remove the rear window reveal molding, pulling the rear window reveal molding slowly away from the body.
- Remove the rear window. Refer to Rear Window Replacement .
Important: You must remove the rear window in order to replace the rear window reveal molding. The original rear window reveal molding (1) must be replaced with a new service part after removal.
Installation Procedure
- Clean the top edge of the window surface with a 50/50 mixture of isopropyl alcohol and water by volume on a dampened lint - free cloth.
- Install the rear window reveal molding (1) to the rear window, starting from the center (1), hand press the rear window reveal molding into place.
- Apply tape if needed, in order to keep the rear window reveal molding on the rear window.
- Install the rear window. Refer to Rear Window Replacement .
Important: The new rear window reveal moldings are primed and will adhere to the urethane adhesive.
Use a heat lamp, or heat gun if needed, in order to make the rear window reveal molding more pliable.
