Removal Procedure
- Turn OFF the ignition.
- Drain the coolant below the level of the ECT sensor. Refer to Cooling System Draining and Filling in Engine Cooling.
- Disconnect the sensor electrical connector.
- Carefully remove the ECT sensor.
Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
Installation Procedure
- Coat the threads with sealer GM P/N 9985253 or equivalent.
- Carefully install the ECT sensor.
- Connect the ECT electrical connector to the sensor.
- Refill the cooling system. Refer to Cooling System Draining and Filling in Engine Cooling.
Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.
Notice: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
Tighten
Tighten the ECT sensor to 20 N·m (15 lb ft).
