- Relieve the fuel system fuel pressure. Refer to
Fuel Pressure Relief
.
- Remove the fuel sender assembly. Refer to
Fuel Sender Assembly Replacement
Caution: Do not drain the fuel into an open container. Never store the fuel in
an open container due to the possibility of a fire or an explosion.
Notice: Do not drain fuel through the fuel tank filler pipe in order to prevent
damage to the fuel tank filler pipe check-ball.
- Use a hand operated fuel pump device in order to drain the fuel through
the fuel sender access panel.
- Install the fuel sender assembly. Refer to
Fuel Sender Assembly Replacement
- Remove the fuel tank filler pipe cap.
- Add fuel.
- Install the fuel tank filler pipe cap.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine Electrical.
- Inspect the fuel system for leaks by performing the following
steps:
9.1. | Turn ON the ignition switch for 2 seconds. |
9.2. | Turn OFF the ignition switch for 10 seconds. |
9.3. | Turn ON the ignition switch. |
9.4. | Inspect for fuel leaks. |